Mitel 5614 DECT Phone User Manual for MiVB
IN CHARGER ACTION WHEN NOT IN CALL
The behaviour of the handset placed in charger when not in call can be set in one of the following
ways:
1. Select “In charger”.
2. Select "Other actions".
3. Select one of the following:
• No action - no action is performed when handset is not in call and placed in charger.
• Change profile - when the handset is placed in the charger it changes profile. When
the handset is removed from the charger, the profile is changed back.
Press "Edit" and select the wanted profile. By default only the profile Normal is select-
able, but additional profiles are visible if they are configured. See Profiles on page 89.
• Switch off - When the handset is placed in the charger it switches off. When it is removed
from the charger it switches on again. NOTE: If handset restrictions are enabled, the
handset might not be switched off when placed in charger.
• Sound off - When the handset is placed in the charger it is muted. When it is removed
from the charger it switches the sound on again. When the handset is switched off in
the charger, the Owner ID of the handset is still displayed. This simplifies the identifi-
cation of the handset when, for example, it is being charged with other handsets. NOTE:
If handset restrictions are enabled, the handset might not be silenced when placed in
charger.
• Logout - When the handset is placed in a charger it is logged off. Call list and message
list are deleted when the handset is logged out. When it is removed from the charger,
the user needs to log on again. NOTE: This feature is applicable in IP-DECT systems
only. See also Log a Shared Phone On and Off on page 30.
• Message absence - When an application or system sends a message to a handset, it
receives an indication that the handset is absent. If a handset is absent, the application
or system determines if the message is to be sent to the handset or not, or redirected
to another handset.
Note: If a message is sent from a handset, it does not receive an indication that the
recipient is absent. This function must be programmed in the PBX to be able to redirect
calls and messages.
NOTE: Additional "In charger" actions to those listed above can also be configured. For
additional information, refer to the Configuration Manual for the handset; see Related
Documents on page 127.
CALLS
1. Enter the menu by pressing the “Menu” Soft key, or the confirmation button on the Navi-
gation key.
2. Select in the menu, and press the confirmation button or the Soft key "Select".
To Next Page
Loading...
