Mitel 5614 - Error and Warning Messages

Mitel 5614 DECT Phone User Manual for MiVB
116
ERROR OR WARNING MESSAGES
2) The IP-DECT system is not
configured for Easy Registration.
2) Subscribe the handset
manually, see
Subscribe Handset
in DECT System Manually
on
page 76,
or
configure the system to
support Easy Registration,
refer to the applicable Installation
and Operation Manual for
your IP-DECT system.
3) There is ambient equipment
disturbing your IP-DECT system.
3) Try to subscribe the
handset in other area in your
building.
4) If the problem still exists,
restart your handset and
subscribe the handset.
DISPLAY SHOWS PROBABLE CAUSE ACTION OR COMMENT
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The handset
beeps once a minute
(during max 30 minutes)
with a low tone followed
by a high tone (if enabled,
the vibrator also follows
the beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound off
key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or contact system administrator.
The message
Failed is
displayed when the
handset tries to
download an ECG
waveform image.
The IP-DECT wireless connection
point is overloaded with too many
calls.
Go refer to the patient. The ECG
Monitoring functionality starts
working when the IP-DECT
connection point is no longer
overloaded.
FAULT PROBABLE CAUSE ACTION OR COMMENT