Mitel 5614 - Page 92

Mitel 5614 DECT Phone User Manual for MiVB
76
NOTE: If no system is found within 2 minutes or "Cancel" is pressed, the handset returns to the
System menu. If this is the case, continue with Subscribe Handset in DECT System Manually.
Notes about Subscribing Handsets and Hot Desking
If the handset is subscribed, but not registered with MiVoice Business or 5000 CP, the handset
will display the following message: "Please login".
• When subscribing the handset to the IP-DECT Base Station, enter the leading 0’s of the
PARK code. Removing the 0’s will prevent subscription.
• After registering the handset with MiVoice Business or the 5000 CP using the System ID,
Extension, and auth password, the "Please Login" message is removed from the handset.
• If you are unable to subscribe the handset, ask the administrator to remove the handset
IPED from the user in the IP-DECT Base Station, if the IPED was pre-programmed for the
user.
If the handset is configured as a Hot Desk handset, then "Please Login" appears for the user
to enter hot desk information.
Subscribe Handset in DECT System Manually
To subscribe an DECT system manually, the “Park:” (Portable Access Right Key) and “Ac:”
(Authentication code) related to the system are needed. Contact the system administrator for
more information. If the handset has been subscribed in one system, additional systems have
to be subscribed manually.
NOTE: The PARK code may not be needed if there is no alien DECT system within the coverage
area.
The IPDI code is a unique code which has been assigned to the handset, see also Admin Menu
on page 108.
1. Select "System".
2. Select "Subscribe".
3. Press "Next".
4. Enter System name (optional). If no system name is entered, the default name is used.
That is System A, System B etc. depending on which system name that is free.
5. Press "Next".
6. Enter PARK code (max. 31 digits). The PARK code may not be needed if there is no alien
DECT system within the coverage area.
7. Enter AC code. The AC code length must be between 4 - 8 digits.
8. Press "Next".
9. An information text "Protection on?" is displayed. Select "Yes" if the new system is to be
protected.
Note: A protected system cannot be unsubscribed via the System menu. The unsubscrib-
tion must be made via the Admin menu or the DECT system.