Mitel 5614 DECT Phone User Manual for MiVB
DTMF
Some systems and PBXs require that the handset sends Dual Tone Multi Frequency (DTMF)
when pressing the keys. DTMF can be enabled as follows:
1. Press the soft key "More" during the call.
2. Select "DTMF".
3. Press "Select". This enables DTMF signals to be used.
DECT INFO
DECT info is an advanced function intended for an administrator using the handset to measure
RF link and system parameters as part of a troubleshooting or site surveying procedure. This
option is only visible if the Admin menu is activated as described in section Admin Menu on
page 108. For more information, refer to the Configuration Manual for the handset; see Related
Documents on page 127.
SEND DATA
User entered data can be sent from the handset by pressing a pre-programmed hot key or soft
key, or selecting a Service. Sent data can be used to initiate actions such as opening a door
or starting and stopping a machine. The data can either be predefined, entered after the hot
key or soft key is pressed, or send when the relevant service is selected.
LOUDSPEAKING FUNCTION
There are five options to activate the loudspeaking function:
• Press a Multifunction button, Navigation key, Hot key or Soft key defined as shortcut to a
"Phone call
" function. When pressing the key/button, a predefined number is called, see
Shortcuts on page 85.
NOTE: The support for Multifunction button is dependent on what model of handset that is
used. For more information, see Functions and Accessories on page 3.
• When receiving a call, press the soft key . The Soft key might have another/no function
depending on its configuration of the In call function in WinPDM/Device Manager.
• During a call, press the soft key . The Soft key might have another/no function depending
on its configuration of the In call function in WinPDM/Device Manager.
• During a call, put the handset in a charger. Requires that Loudspeaking is chosen in the In
Charger menu.
• This function can also be activated by selecting another answering method, that is, "Auto-
matically" and/or "Loudspeaking". See Answering on page 98.
Note: This option is only visible if configured in the handset. For more information, refer
to the Configuration Manual for the handset; see Related Documents on page 127.
Tip: The handset can also be configured to send DTMF when pressing and pressing
releasing . refer to the Configuration Manual for the handset; see Related Documents
on page 127.
To Next Page
Loading...
