EasyManua.ls Logo

Mitel 5614 - FCC and IC Compliance Statements

Mitel 5614
159 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
139
REGULATORY COMPLIANCE STATEMENTS (USA AND CANADA
ONLY)
FCC AND IC COMPLIANCE STATEMENTS
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antennas.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Privacy of communications may not be ensured when using this handset.
EXPOSURE TO RADIO FREQUENCY SIGNALS
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device complies with FCC SAR limit of 1.6 W/kg. The maximum SAR value
measured, see below.
The handset is designed to be worn with the display towards the body for best radio
performance. SAR testing is made with no separation, to approve the device to be carried close
to the body.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
Use of non-approved accessories may violate the FCC and IC guidelines for RF exposure and
should be avoided.
FCC ID:
DH7-xBxx:BXZDH7BT
DH7-xDxx:BXZDH7BT
DH7-xAxx:BXZDH7
IC:
DH7-xBxx:3724B-DH7BT
DH7-xDxx:3724B-DH7BT
DH7-xAxx:3724B-DH7
Head Body
DH7-xxxx 0.042 W/kg 0.074 W/kg

Table of Contents

Other manuals for Mitel 5614

Related product manuals