Mitsubishi Electric MELSEC iQ-R16MTCPU - Digital Oscilloscope Operating Procedure; Sampling Settings File

7 DIGITAL OSCILLOSCOPE
7.4 Digital Oscilloscope Operating Procedure
339
7
7.4 Digital Oscilloscope Operating Procedure
The digital oscilloscope sampling operating procedure is described below. The digital oscilloscope is operated using MT
Developer2. Set clock data before using the digital oscilloscope. File name time information is created based on the clock
data setting. (Page 113 Clock Function)
Furthermore, if using an SD memory card, the card must be formatted. (Page 350 SD memory card handling)
*1 Operation is possible even if not connected to the digital oscilloscope.
*2 Sampling results are displayed automatically, however, sampling results files can also be read later.
7.5 Sampling Settings File
The sampling settings file is a file used to set information required for sampling such as the sampling interval and probe data.
The sampling settings file is saved to the standard ROM or to an SD memory card. Sampling is started by specifying the
sampling settings file storage target. The sampling settings file setting items are as follows.
File type Setting item
Sampling settings file Sampling interval
Sampling target
Trigger settings
Save settings
NO
NO
YES
YES
Use SD memory card?
Insert SD memory card in Motion
CPU.
START
Specify settings required for
sampling at digital oscilloscope.
Write sampling settings file to
Motion CPU standard ROM or SD
memory card.
Start sampling from
digital oscilloscope?
Start sampling with digital
oscilloscope RUN.
The digital oscilloscope sampling
results are displayed automatically.
*2
END
Sampling results are stored in the
specified save target.
Start sampling with "Sampling
settings RUN request (SM860)".
*1