Mitsubishi Electric MELSEC iQ-R16MTCPU - Manual Pulse Generator Connection Setting

70
2 COMMON PARAMETERS
2.3 Motion CPU Common Parameter
Manual pulse generator connection setting
This section describes the manual pulse generator connection setting items.
[Motion CPU Common Parameter]  [Manual Pulse Generator Connection Setting]
Window
Displayed items
Valid setting
Enable/disable the manual pulse generator (P1 to P3).
I/O No.
Set the start I/O No. for the high-speed counter module used to connect the manual pulse generator. Set the high-speed
counter module as the Motion CPU management module in the GX Works3 "System Parameters"  "I/O Assignment
Setting".
CH No.
Set the channel number for the high-speed counter module used to connect the manual pulse generator. The same channel
number for the same module can be set to overlap in manual pulse generator (P1 to P3).
Refer to the following for details on the manual pulse generator.
MELSEC iQ-R Motion Controller Programming Manual (Positioning Control)
Item Setting range Default value
Valid setting 0: Invalid/1: Valid 0: Invalid
I/O No. H0000 to H0FF0 No setting
CH No. 1 to 2 No setting
Setting range Details
0: Invalid Does not connect the manual pulse generator (P1 to P3).
1: Valid Connects the manual pulse generator (P1 to P3).
Setting range
H0000 to H0FF0
Setting range
1 to 2