8 MOTION CPU MEMORY STRUCTURE
8.1 Memory and Files
349
8
*1 For operating system software version "09" or earlier, df_k0000.prg to df_k4095.prg.
*2 For operating system software version "09" or earlier, df_sf000.prg to df_sf255.prg.
*3 When expansion settings in operating system software version "10" or later are disabled, or for operating system software version "09"
or earlier, servo.prg (servo program file), motsfcpr.bin (Motion SFC parameter file), motsfc.prg (Motion SFC program file).
*4 Elapsed time (seconds) up to the current time using Greenwich Mean Time 00:00:00, January 1st 1970 as the reference (hexadecimal
notation)
*5 Created when "Access from external device" is set in label setting of MT Developer2. Do not change the files in the folder.
*6 For operating system software version "02" or earlier, the file names are DEVCMNT.IFG (device comment file), and GL_LABEL.DCM
(label/structure file).
If the files required by the Motion CPU do not exist in the folder, a moderate error (error code: 2200H) occurs,
and the Motion CPU does not RUN.
Digital oscilloscope settings file
Digital oscilloscope sampling data file
osc01.csv
********.csv
Database folder (storage path of database for label communication)
*5
*5
*3
*4
*3
Database system folder (storage path of database system setting file)
Boot log file (previous boot log)bootlog.bak
Event history fileEVENT.LOG
Label/structure fileGL_LABEL.IF2
Device comment fileDEVCMNT.DC2
Boot log filebootlog.txt
/data/
oscout01/
/$LBLDB$/
/
$LDBSYS$
/
(1)
/gcode/ prog/
G-code control program fileO001.gcd to O256.gcd
temp/
G-code control program file
(For program file load while running)
O001.gcd to O256.gcd
G-code control system parameter filegcdsys01.csv, gcdsys02.csv
G-code control axis parameter file (line 1)gcd1ax1.csv to gcd1ax8.csv
G-code control axis parameter file (line 2)gcd2ax1.csv to gcd2ax8.csv
G-code control work parametergcdproc.csv
To Next Page
Loading...
