SECTION 3: WIRING AND INSTALLATION T200 User's Manual
PAGE 3-55
Fuse Holder
- Operation of the T200 with other than the factory fitted fuse type
for the particular regen resistor configuration may cause equipment malfunction
and/or damage and may result in the equipment becoming unsafe.
- When performing any changes to the regen resistor configuration,
a.c. input power must be removed from the T200. Wait 5 minutes upon removal
of all power, to allow for D.C. Bus capacitors to discharge. Do not operate the
T200 with the cover removed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
