Morris PROAG 16K PLUS - Raise Bed; Lower Bed; Power Slide Back; Power Slide Return; Push off out

Troubleshooting
16K PLUS October 2019 8-9
16k PLUS Control System - Continued
Crash Avoidance - Continued
Raise Bed / Lower Bed
If the loader down, raising or lowering the bed could cause the loader to crash into the hitch. Also, if the pushoff is
extended, raising or lowering the bed could serious damage to the pushoff.
Note. If the bed is lowered below the mid position with the loader down, you mush switch to Manual Mode
to raise the loader before you can continue.
• The following screen Warning screen will be displayed in the Manual Stack screen if the Crash Avoidance has
been activated:
To raise or lower the bed, the operator must either:
• Retract the pushoff completely
And / Or
• Raise the loader completely.
Power Slide Back / Power Slide Return
If the loader down, moving the power slide could cause it to dig into the ground. The loader must be fully raised to
move the power slide
• The following screen Warning screen will be displayed in the Manual Load screen if the Crash Avoidance has
been activated:
To operate the power slide:
• Raise the loader completely.
Push Off Out
If the bed is not fully raised, extending the Push Off could cause a collision.
• The following screen Warning screen will be displayed in the Manual Stack screen if the Crash Avoidance has
been activated:
To operate the Push Off:
• Raise the bed fully.