Safety
1-10 October 2019 16K PLUS
DANGER
To prevent serious injury or death
from crushing:
Stand clear of machine and stack to
avoid being struck by falling bale.
10110
Part # 10110 – Danger Falling Bale Hazard
Location: Both sides of bed.
DANGER
CRUSHING HAZARD
• Always rest loader on hitch
and turn off tractor before
working on loader.
10111
Part # 10111 Danger Crushing Hazard
Location: Left side of bed.
Safety Signs
Safety Decals
• Keep safety decals and signs clean and legible at all times.
• Replace safety decals and signs that are missing or have become illegible.
• Parts that have been replaced that once displayed a safety sign should have the sign replaced as well.
• Safety decals or signs are available from your distributor, dealer parts department, or the manufacturer.
How to install a new decal
1. Be sure that the installation area is clean and dry.
2. Decide on the exact position before you remove the backing paper.
3. Remove the smallest portion of the split backing paper.
4. Align the decal over the specied area and carefully press the small portion with the exposed sticky backing in
place.
5. Slowly peel back the remaining paper and carefully smooth the remaining portion of the decal in place.
6. Small air pockets can be pierced with a pin and smoothed out using the decal backing paper.
To determine missing decals, or to locate proper locations for replacements refer to the “Decal Location
Guide” later in this section.
To Next Page
Loading...
