Morris PROAG 16K PLUS - Daily Maintenance

Maintenance
6-6 October 2019 16K PLUS
Daily Maintenance
WARNING: After the first 100 hours of use, re-torque all wheel lug nuts.
Daily Check
Lubricate Lubricate all grease points with all-purpose, non-clay based grease. See “Lubrication”
section for location of grease zerks.
Hitch Connection Check the bolt system that connects the stacker to the tractor drawbar. A loose
connection will wear faster and possibly uncouple.
Inspect Pins Check to make sure all pins and bolts are secure in their proper places. Inspect the
pivot pins for wear and replace as necessary.
Inspect Plastic Check all plastic wear plates for wear or breakage. See section in general
maintenance.
Inspect Hydraulics Inspect all hydraulic hoses, ttings, and couplings for signs of wear and x as
necessary. Check hydraulic uid in tractor and general hydraulic system as outlined
above.
Clean Keep the Bale Runner clean and free from mud and dirt, especially around hydraulic
cylinder rods and moving parts.
Axle Bearings Check the oil level in the axle hubs and ll with 80-90 gear lube as necessary.
Wheel Lug Nuts Examine the wheel lug nuts making sure all are tight and none are missing.
Tire Air Pressure Check air pressure in tires. Tire pressures for specic tires are listed in the
“Machine Specication” section at the front of this manual.
Wiring Harness Make sure wires are not rubbing on sharp metal objects etc.
Lighting Check to be sure all lights (brake, turn and clearance) are intact and functioning
properly.
 Brakes Check brakes for adjustment periodically.
 Sensors Wipe off dust and metal from all ferrous metal sensors.