Operation
16K PLUS October 2019 5-21
Stacking Bales - Continued
Stacking a Full Load With No Back-Stop
This practice is not recommended, as part of the stack
may fall over during this procedure.
• When stacking a full load with no back stop or existing
stack,
• Raise the bed to a 60 - 70 degree angle.
• Open the alignment arms and Lower the loader
slightly.
• Squeeze the alignment arms and raise the loader
again to compress the bales between the alignment
arms and forks.
• Very carefully proceed to unload normally. Be aware
without a proper backstop part of the stack may fall
over during this procedure.
Stacking Side-By-Side
• Create a single row in each stack starting from right
to left.
• Add second row from right to left.
• Continue this procedure until stack is completed.
Warning
Stand Clear, part of the stack may fall over
during this procedure without a proper
backstop.
To Next Page
Loading...