Operation
16K PLUS October 2019 5-29
Resetting Power Slide
In order to load bales in automatic mode, the power
slide must be in the Home Position.
Resetting the power slide Home Position is done in the
Manual Load screen.
Important: The following sequence must be used.
• In Manual Stack screen, position the Power Slide at
the foot of the loader.
• Press F2 button to reset the Power Slide position.
• Press F4 button to conrm
• Manually move Power Slide to Home Position,
underneath the loader, approximately under the
center Bale Claw.
• Return to Auto screen, the green checkmark
should be displayed for the Power Slide.
Power Slide at Foot of Loader
Power Slide at Home Position
To Next Page
Loading...
