Troubleshooting
Problem Cause
Correction
16K PLUS October 2019 8-21
Push Off Out/In
Hitch Inline/Offset
Crash Avoidance
Check current output
Check valve solenoid
Crash Avoidance
Check Sensors
Hitch transport pin is in
Check current output
Check valve solenoid
Push Off Out: Use the “Measure - Sensors” menu
to ensure the Bed Up sensor is true.
Push Off In: None
The current output can only be checked in Auto
mode. Use the “Measure - Outputs” menu. When
“Push Off Out” is “true” the computer is sending
12V to the valve to extend the push off. When “Push
Off In” is “true” the computer is sending 12V to the
valve to retract the push off.
Use procedure described in “Checking Valve
Solenoids” to check the operation of the valve.
Both Manual and Auto Mode:
If the bed is down, use the “Measure - Sensors”
menu to ensure the Loader Up sensor is true.
- OR -
If the bed is raised and the loader is down, use
“Measure - Sensors” menu to ensure the bed mid
sensor is true.
Use the “Measure - Sensors” menu to view the
state of the hitch inline and hitch offset sensors.
The hitch will not move inline if the hitch inline
sensor is true. Similarly, the hitch will not offset if
the hitch offset sensor is true.
Remove pin. It may be necessary to unplug
the Hitch Inline sensor to relieve pressure in the
cylinder if the hitch offset button was pressed with
the pin in place.
Use “Measure - Outputs” menu to check amperage
going to the Hitch valve. The monitor should display
a negative amperage when moving the hitch
offset, and a positive amperage when moving the
hitch inline. (If there is a broken wire or shorted
wire to the valve, the monitor may show an error
message.)
Use procedure described in “Checking Valve
Solenoids” to check the operation of the valve.
To Next Page
Loading...
