Name: Motion Control Engineering Nidec iControl
Brand: Motion Control Engineering
Rating: 4 (1 reviews)

To Next Page

To Previous Page

5-29

Serial Hall Call

iControl AC

TCP Address Check, -ME Board The Digi Device Discovery utility may be used to

check and/or reset the TCP/IP address of the serial/Ethernet assembly (SC-HCE-ME). This

utility is available from MCE.

1. Start the Digi Device Discovery utility. The utility will launch, and check the System net-

work for any connected SC-HCE-ME.

2. Select the device. Click on Configure Network Settings.

Note that, to change Digi configuration, you will need to provide USN Name and Password:

•Default USN Name: root

• Default USN Password: dbps

Questions and Answers:

Need help?

Do you have a question about the Motion Control Engineering Nidec iControl and is the answer not in the manual?

Motion Control Engineering Nidec iControl Specifications

General