Motion Control Engineering Nidec iControl User Manual

4-1
In This Section
This section describes final adjustment inspection of the elevator. At this point, all steps in Sec-
tions 2 and 3 should have been completed.
• Learning the Floor Heights (see page 4-2).
• Verifying One-Floor Run Operation (see page 4-3).
• Reaching Contract Speed (see page 4-6).
• Learning Normal & Emergency Terminal Limit Switches (see page 4-8).
• Shaping the Speed Profile (see page 4-12).
• Controlling the Start of Car Motion (see page 4-16).
• Calibrating the Floor Offsets (see page 4-22).
• Adjusting Leveling and Final Stop (see page 4-25).
• Load Weigher Adjustment for Dispatching (see page 4-30).
• Pre-Start Sequence (see page 4-35).
• Calibration and Verification of Safety Functions (see page 4-40).
• Safety Tests (see page 4-42).
• Terminal Switch Faults (see page 4-54).
Final Adjustment

Motion Control Engineering Nidec iControl Specifications

General

Brand	Motion Control Engineering
Model	Nidec iControl
Category	Control Unit
Language	English