Index-3
Car out of service with doors stalled message 6-20
Car Over Load Activated message 6-20
Car Over Load Deactivated message 6-20
CAR OVERLOAD message 6-20
Car Panel (Hoistway) Access Enable switch input 6-110, 9-7
Car Panel Emergency Stop switch input 6-110, 9-7
Car Panel Insp message 6-21
Car Panel Inspection Disabled message 6-20
Car Panel Inspection Enabled message 6-20
Car Panel Inspection Inputs OK message 6-21
Car Panel Inspection message 6-21
Car Panel Inspection Operation message 6-21
Car Reaction 4-55
Car shut down due to emergency power operation with no su-
pervisor (Activated) message 6-21
Car shut down due to emergency power operation with no su-
pervisor (Deactivated) message 6-21
Car Speed specification 9-2
CAR STOP SWITCH OPEN message 6-21
Car Stop Switch Open message 6-21
Car Top, iBox status LED 7-10
Car/Counterweight Buffer Test 4-45
Car/Counterweight Safety Test 4-44
CARTOP AUTO UIM FLT message 6-22
Cartop Automatic Unintended Motion Fault message 6-22
CARTOP COMM FAULT message 6-22
Cartop Communication Fault message 6-22
Cartop Emergency Stop message 6-22
Cartop Exit no Counterweight Configuration Error message
6-22
CARTOP EXIT OPEN message 6-22
Cartop Exit Open message 6-22
Cartop Exit Open Off message 6-22
Cartop Firmware Update Mode message 6-22
CARTOP FW UPDATE MODE message 6-22
Cartop Insp message 6-23
CARTOP INSP UIM FLT message 6-23
Cartop Inspection Disabled message 6-23
Cartop Inspection Enabled message 6-23
Cartop Inspection Inputs OK message 6-23
Cartop Inspection message 6-23
Cartop Inspection Operation message 6-23
Cartop Inspection Unintended Motion Fault message 6-23
Cartop Inspection Wiring 2-13
Cartop interconnections 1-5
Cartop Link Connections, iBox 6-110, 9-7
Cartop Power Loss message 6-23
Cartop Processor Board Quick Reference 6-86
Cartop Safety Relay 2-12
Cartop Safety Relay Bypass 2-12, 2-13
Cartop Safety Switches 2-12
CFSS 1 at floor message 6-23
CFSS 1 In-car message 6-23
CFSS 1 recall message 6-23
CFSS 2 at floor message 6-23
CFSS 2 In-car message 6-23
CFSS 2 Recall message 6-23
CFSS Mode 1 at Floor Activated message 6-23
CFSS Mode 1 In-car Activated message 6-23
CFSS Mode 1 Recall Activated message 6-23
CFSS Mode 2 at Floor Activated message 6-23
CFSS Mode 2 In-car Activated message 6-23
CFSS Mode 2 Recall Activated message 6-23
Changing parameters 2-14
Check for shorts to ground 2-6
Checking AC phase 5-2
Checking the Hoist Motor 2-9
Circuit boards, troubleshooting 6-82–??
Clear drive error 2-29, 9-67
Clone Controller Data 7-7
CNPB Fault, see Brake Contactor Proofing Fault message 6-15
CNPBD Fault, see Brake Contactor Driver Proofing Fault
message 6-15
CNPM Fault, see Motor Contactor Proofing Fault message 6-
56
CNPMB Fault, see Motor Contactor Driver Proofing Fault
message 6-56
Cnstr Car Panel Insp message 6-23
Cnstr Cartop Insp message 6-24
Cnstr CP Insp message 6-23
Cnstr CT Insp message 6-24
Cnstr HA Insp message 6-24
Cnstr HA Inspection message 6-24
Cnstr Inspection message 6-24
Cnstr Mach Room Insp message 6-24
Cnstr MR Insp message 6-24
Common Bus Connections, iBox 9-11
Computer IP address, setting 5-5, 5-8, 8-5
Computer Reset, iBox control 7-3
Computer, iBox status LED 7-10
conF 9-69
Configuration File 6-80
Configuration file
creating 8-21
editing 8-23
loading 8-22
saving 8-21
Configuration File - Generate Default 8-20
Connected 5-13
Connection Status 5-13
Construction Car Panel Inspection Operation message 6-23,
6-24
Construction Cartop Inspection Operation message 6-24
Construction Hoistway Access Inspection Operation message
6-24
Construction Inspection Operation message 6-24
Construction Machine Room Inspection Operation message
6-24
Construction Mode 2-1–2-51, 3-1–3-9
exiting 3-9
Faults 2-2
Required connections 2-2
Contract Overspeed Test 4-45, 4-47
Controller Main Computer Startup message 6-24
Controller Specifications 9-2
Controller Stop switch, iBox control 7-11
Correction profile 4-13
Counterweight balancing, preparing for final adjustments 3-
12
Counterweight derailment detector 3-6
To Next Page