Users Guide ValueJet 1614
68 AP-75790 Rev 1.4 -22/02/2011,
Step 17 : Press the [ENTER] key on the operation panel
Start "Bi-D normal" pattern printing.
Check the BI-D normal pattern printing and select the number corresponding to the lines that are most
closely aligned.
4 is selected in the next printing sample.
Step 18 : Press the [+] or [] key to set the number that you have selected.
Step 19 : Press the [Enter] key on the operation panel.
The set value for BI-D normal is registered.
Adjust5 BI-D Normal is displayed on the operation panel.
Register the setting for Bi-D SPEED (two-way printing/SPEED mode) in the same way as in previous
steps.
Step 20 : Press the [CANCEL] key on the operation panel to exit from the setup.
To Next Page
Loading...
