PMM 9030/9060/9180 Frequency Extension 11-57
During the firmware storing procedure the operation, the SW shows the file
in progress of uploading (below it is shown the PMM 9180 Firmware
updating process as example):
The message “N° Bytes have been stored” appears at the process end,
showing the number of Bytes written into the instrument.
To use the PMM 9030/9060/9180 with the PMM 9010F, the following
Firmware and FPGA release are needed:
- PMM 9010F: 9010F_FW.ldr rel. 1.17 or higher
Check.bin file (No Release)
Radied.bin file (No Release)
- PMM 9030: 9030FW.ldr rel. 1.19 or higher.
run9030.bin rel. 0x19 or higher.
- PMM 9060: 9060FW.ldr rel. 1.20 or higher.
run9060.bin rel. 0x16 or higher
- PMM 9180: 9180FW.ldr rel. 1.19 or higher.
run9180.bin rel. 0x13 or higher
For updating the firmware of the 9010F, please refer to the Chapter 8
and in addition pay attention to update the FPGA for radiated too.
In case the release should not comply with what expected, just check
about the FW file used during installation or get in contact with the
nearest NARDA Local Distributor.
To Next Page
Loading...
Need help?
General
