89
Cirrus LT Plus User Manual v1.2 - Chapter 4
Setting the duration of the OnScreen Menu (OSM) Timeout
There are two ways to set the OSM Timeout interval. The first way can be set
within the OSM itself, under Power Management > Power Settings > OSM Time-
out. The second way is via Teradici’s Firmware Menu.
Via the OSM Power Management > Power Settings > OSM Timeout
To change the timeout duration via the OnScreen Menu Timeout:
1. Click the Power Management submenu, and then click the OSM Timeout
bar, as shown below.
2. The Menu Display Time Out Section will appear, as shown below. You
may choose between Do Not Sleep, 1 Minute, 5 Minutes, 15 Minutes, 30
Minutes, or 60 Minutes (5 Minutes is the default setting).
3. Select the desired interval and click on ‘Settings’ to return to the Power
Savings Menu.
To Next Page
Loading...