96 Cirrus LT Plus User Manual v1.2 - Chapter 4
Enable in Session
Enabling this mode will put the unit to sleep within the selected amount of time
of inactivity even if in a remote session.
To Enable In Session Mode:
1. Click the Power Management submenu.
2. Click the box next to Enable In Session. When the green ‘check mark’ is
selected, Enable In Session Mode will then be turned on.
If Enabling In Session and Low Power Mode are both turned on:
1. When Enable In Session and Low Power Mode are enabled simultaneous-
ly (as shown below),the low power modes Sleep Mode and Auto Power Off
will work even while connected to a remote host.
To Next Page
Loading...