DS1000/2000 Correspondence Course
Using Your Telephone
NEC America DS1000/2000 Workbook ◆ 15
You can refer to the DS1000/2000 Software Manual for more information on
what each program does as well as information on programming the keys.
Depending on your software version (2.00.00 or higher required) and the access
level assigned to the extension (Program 1801), an end user can also customize
their phone with the User Programmable Features.
Note: The previous Speed Dial programming procedures (##2 for System Speed
Dial and ##7 for Personal Speed Dial) are no longer available. You must use the
User Programmable Feature steps for Speed Dial instead.
User Programmable Features
Feature Mnemonic Operation Access Level
The shaded rows below show the Fixed Slot software User Programmable Features.
Call Coverage
#RC
# + R C + Press Call Coverage key
repeatedly to select ringing mode
N/A
DSS
#BLF
See DS1000: Installing a DSS Con-
sole
(page 65) or DS2000: Installing
a DSS Console
(page 110) before
using this option.
#BLF + Press DSS key + HOLD + Enter
extension + VOL Up + Program another
key or SPK to exit.
1-5
Group Call Pickup
#RG
# + R G + Press Group Call Pickup key
repeatedly to select ringing mode
N/A
Headset
#HS
#HS
+ Y to enable or N to disable + SPK
to exit
3-5
Hotline
#HL
#HL
+ Press flashing Hotline key + Enter
extension for new Hotline partner +
HOLD + Program another Hotline key or
SPK to exit.
3-5
Line Keys
#RL
# + R L + Press Line Key repeatedly to
select ringing mode
N/A
Off Hook Signaling and
Voice Over
#OHS
#OHS
+ Select mode (C=Outside line,
D=Hotline, I=ICM) + Select option (see
below) + SPK to exit.
Outside line options: C=Camp On tone,
O=Off Hook Ringing, 0 = None
Intercom options: C=Camp On, V=Voice
Over, 0 = None
Hotline Options: C=Camp On, 0 = None
3-5
Paging (Incoming)
#VP
#VP
+ Y to enable or N to disable + SPK
to exit.
3-5
Prime Line Assignment
#PLA
#PLA
+ Press one of your flashing pro-
grammable keys or ICM + SPK to exit.
3-5
To Next Page
Loading...
Need help?
General
