NEC NEAX 2000 IPS - Page 113

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 99 – NWA-008853-001 Rev.3.0
97ch3001.fm
DESCRIPTION DATA
Assign a trunk route number to each DTI/CCT.
NOTE 1: The trunk routes used for a common
signaling channel must be different
from the trunk routes used for voice
channels.
NOTE 2: If channel number 16 is assigned as
Common Signaling channel, all
channels in the DTI/CCT must be
assigned as No. 7 CCIS trunk.
NOTE 3: The DTI/CCT route must be sepa-
rated from any analog trunk route.
•
(1)
(2)
Y=00
000-254: Trunk No. assigned by CM07
Y=01
00-63: Trunk Route No.
Assign the trunk route data for common sig-
naling channel and voice channels.
Minimum of two routes.
•
(1)
(2)
Y=00
00-63: Trunk Route No.
04: Tie Line
•
(1)
(2)
Y=01
00-63: Trunk Route No.
7: DP/DTMF
•
(1)
(2)
Y=04
00-63: Trunk Route No.
2: Answer Signal arrives
•
(1)
(2)
Y=05
00-63: Trunk Route No.
1 : Release Signal arrives
Specify the incoming connection signal. •
(1)
(2)
Y=09
00-63: Trunk Route No.
03: Wink Start/CCIS
Specify the outgoing start condition. •
(1)
(2)
Y=20
00-63: Trunk Route No.
00: Wink Start/CCIS
B
CM30
CM35
C
DIGITAL CCIS PROGRAMMING