NEC NEAX 2000 IPS - Page 139

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 125 – NWA-008853-001 Rev.3.0
97ch3001.fm
DESCRIPTION DATA
Assign a service feature access key for LCR
Group 0-2 to D
term
, if required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0A26-F0A28: LCR Group 0-2
Assign the Area Code Development Pattern
number for maximum digit analysis to each
trunk route.
•
(1)
(2)
Y=76
00-63: Trunk Route No.
05-07: Area Code Development Pattern
No. 5-7
Assign an Area Code Development Pattern
number to each LCR Group.
•
(1)
(2)
Y=A000
0-3: LCR Group 0-3
4005-4007: Area Code Development Pat-
tern No. 5-7
Assign a Route Pattern number to each area
code for the Area Code Development Pattern
number assigned by CM8A Y=A000.
•
(1)
(2)
Y=4005-4007 Area Code Development
Pattern No. 5-7
X...X: Area Code, Maximum 8 digits
0000-0255: Route Pattern No. 000-255
Assign a LCR Pattern number to each area
code for the Area Code Development Pattern
number assigned by CM8A Y=A000.
•
(1)
(2)
Y=4005-4007 Area Code Development
Pattern No. 5-7
X...X: Area Code, Maximum 8 digits
5000-5255: LCR Pattern No. 000-255
For area code deletion, designate the digits to
be not deleted.
•
(1)
(2)
Y=5000-5255 LCR Pattern No. 000-255
152: Deletion of all digits of the area code
assigned by CM8A Y=4005-4007
1 : Not deleted
Assign the next Route Pattern number to the
Route Pattern number assigned by CM8A
Y=4005-4007.
NOTE: This data is required to expand the
order of LCR selection that is as-
signed by CM8A Y=0000-0255.
The order of LCR selection can be
expand to the maximum seventh.
•
(1)
(2)
Y=0000-0255 Route Pattern No. 000-255
0: Designation of next table
0000-0255: Next Route Pattern No. 000-
255
A
CM90
,
CM35
CM8A
B
JANUARY/31/2006
DIGITAL CCIS PROGRAMMING