CHAPTER 3 SYSTEM DATA PROGRAMMING
– 163 – NWA-008853-001 Rev.3.0
97ch3002.fm
Operating Procedure
Single Line Telephone
To set a Call Forwarding-Busy Line-CCIS from a Single Line Telephone:
1. Lift the handset and receive dial tone.
2. Dial the Call Forwarding-Busy Line feature access code and receive Feature Dial Tone.
3. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
4. Dial the desired target station number and receive Service Set Tone.
5. Wait approximately five seconds and receive Service Set Tone.
To cancel a Call Forwarding-Busy Line-CCIS from a Single Line Telephone:
1. Lift the handset and receive dial tone.
2. Dial the Call Forwarding-Busy Line cancellation code and receive Service Set Tone.
Attendant Console
To set a Call Forwarding-Busy Line-CCIS from an Attendant Console:
1. Press an idle LOOP key.
2. Dial the Call Forwarding-Busy Line feature access code and receive Feature Dial Tone.
3. Dial the originating station number.
4. Dial the outgoing trunk access code and receive a single burst of Service Set Tone.
(This operation is required for a network using Open Numbering Plan.)
5. Dial the desired target station number and receive Service Set Tone.
6. Press the RELEASE key.
To cancel a Call Forwarding-Busy Line-CCIS from an Attendant Console:
1. Press an idle LOOP key.
2. Dial the Call Forwarding-Busy Line cancellation code and receive Feature Dial Tone.
3. Dial the originating station number and receive Service Set Tone.
NOTE: The Attendant Console can only set/cancel Call Forwarding-Busy Line for stations within the
local system in which the Attendant Console resides.
JANUARY/31/2006
CALL FORWARDING-BUSY LINE-CCIS/MULTIPLE CALL FORWARDING-BUSY LINE-CCIS
To Next Page
Loading...
