NEC NEAX 2000 IPS - Page 181

CHAPTER 3 SYSTEM DATA PROGRAMMING
– 167 – NWA-008853-001 Rev.3.0
97ch3002.fm
DESCRIPTION DATA
Allow or restrict Multiple Call Forwarding-All
Calls/Busy Line/Don’t Answer-CCIS for each
CCH number.
•
(1)
(2)
Y=29
0-7: CCH No.
0 : Allowed
1 : Restricted (Only once)
Specify the number of times of Multiple Call
Forwarding-All Calls/Busy Line/Don’t An-
swer-CCIS.
(1)
(2)
72
01-07: 1 time-7 times
If no data is set, the default setting is 5
times.
Provide Call Forwarding feature with each ten-
ant as per incoming call type.
•
•
•
(1)
(2)
Y=23
Internal Call or ATT assisted call
Y=24 C.O. Incoming Call
Y=25 Tie Line Incoming Call
00-63: Tenant No.
1 : Call Forwarding
Specify the timing for Call Forwarding-Don’t
Answer for a trunk incoming call.
•
(1)
(2)
Y=0
01
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36 sec-
onds.
Specify the timing for Call Forwarding-Don’t
Answer for an internal call or an assisted call.
•
(1)
(2)
Y=0
15
01-30: 4-120 seconds
(4 second increments)
If no data is set, the default setting is 32-36 sec-
onds.
Assign the Call Forwarding-Don’t Answer key
to a D
term
, if desired.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0016: Call Forwarding-Don’t Answer
Set/Cancel
For setting the same key as Call Forwarding-
Busy Line:
(1)
(2)
My Line No. + + Key No.
F0012: Call Forwarding-Don’t Answer/
Busy Line Set/Cancel
B
CMA7
CM42
CM65
CM41
CM90
,
,
END
CALL FORWARDING-DON’T ANSWER-CCIS/MULTIPLE CALL FORWARDING-DON’T ANSWER-CCIS