CHAPTER 3 SYSTEM DATA PROGRAMMING
– 195 – NWA-008853-001 Rev.3.0
97ch3003.fm
AP Initialization (PN-AP00-B/PN-AP00-D with MRCA program)
[Series 3300 software required]
This section explains the data assignment to make the AP active. If the system already applied the AP re-
lated feature, you can skip the data assignment explained on this section. The AP should have already ac-
tivated if one of the following feature applied; Station Message Detail Recording (SMDR), Message
Center Interface (MCI), D
term
TIMS (Time Information Management System), Hotel printer, or Do Not
Disturb set/cancel at specified timing in advance. You can distinguish whether the AP active or not by the
RUN lamp indication. The RUN lamp flashes on green color when the AP is in active.
When installing the AP00 at first time, do the following AP initialization.
DESCRIPTION DATA
Assign an AP number to the AP00 card.
The AP number must match the SENSE switch
setting on the AP00 card.
•
(1)
(2)
Y=0
04-15, 20-31: AP No.
45: AP00 with MRCA program
On the AP00 card, set the SW1 switch as
shown below.
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
(1)
(2)
0000
CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
START
CM05
INITIAL
SW1
ON
: POSITION TO BE SET
4
3
2
1
CMDD99
AP OFF LINE
SW 1
ON
: POSITION TO BE SET
4
3
2
1
A
JULY/01/2006
CENTRALIZED BILLING-CCIS
To Next Page
Loading...
