CHAPTER 1 GENERAL INFORMATION
– 14 – NWA-008853-001 Rev.3.0
97ch1001.fm
Conditions for Local Office;
- The available combination between SMDR and the output format is as follows. One type of SMDR is
available among the following SMDR in local office.
- The AP00 cannot be used when MP built-in SMDR is provided in local office (CM08>800: 0).
- The MP built-in SMDR cannot be used when the AP00 is provided in local office (CM05 Y=0: 04).
- In case of using AP00, the billing information of local office can be sent to the SMDR terminal of the
local office.
- In case of using MP built-in SMDR, the billing information of local office cannot be sent to the SMDR
terminal of the local office.
- In case of using AP00, if the link between local office and center office is shut down due to such as a
failure of center office, the billing information is stored in the local office. In this case, the billing infor-
mation will not be cleared by the MP reset or power off.
- In case of using MP built-in SMDR, if the link between local office and center office is shut down due
to such as a failure of center office, the billing information is stored in the local office. In this case, the
billing information will be cleared by the MP reset or power off.
- Maximum of 3600 calls per hour can be sent to center office/tandem office.
SMDR
Former NEAX 2400 IMS
format
Extended NEAX 2400 IMS
format
SMDR with AP00
(AP00 with AP00
program)
Available Not Available
SMDR with AP00
(AP00 with MRCA
program)
Available Not Available
MP built-in SMDR on
RS-232C
Available Available
[Series 3400 software or later]
MP built-in SMDR on IP Not Available Not Available
SYSTEM OUTLINE
To Next Page
Loading...
