NEC NEAX 2400 ICS - Page 141

NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 111
Call Forwarding - All Calls - D
term
C-5D
Interactions
1. Station users are unaccustomed to hearing Ringback Tone when responding to their own
station’s ring. Inform users when providing Ringback Tone with CALL FORWARDING-ALL
CALLS in System Data 1, Index 69, Bit 1.
2. Call Forwarding can only be activated from an idle station.
3. When CALL WAITING [C-12, 31], ATTENDANT CAMP-ON [A-1], and CALL BACK [C-1] are
directed toward Station A, with CALL FORWARDING set to Station B, Station B will receive Call
Waiting Tone.
4. When a station in a STATION HUNTING [S-7, 8, 9] Group initiates CALL FORWARDING-ALL
CALLS, calls normally destined for this station will not be received. The Hunt Group operates as
if the station were busy.
5. A noncontrolling UCD station is allowed to activate CALL FORWARDING [C-5]. With this station
call forwarded, only calls that are directly dialed to this station are call forwarded. The member
station is removed from the UCD group under the conditions of this call forwarding feature.
6. If an Attendant attempts BUSY VERIFICATION [B-3] to Station A, which has CALL
FORWARDING-ALL CALLS set to Station B, BUSY VERIFICATION [B-3] proceeds as if the
Attendant had attempted to Verify Station B. If Station A has set CALL FORWARDING-ALL
CALLS to the Attendant Console, BUSY VERIFICATION [B-3] is allowed at Station A if Station
A is busy.
7. When CALL FORWARDING-ALL CALLS is in effect, the call forwarded station may be used to
originate calls. See System Data 2, Index 6 Bit 4.
8. When a station is call forwarded, the destination station is recorded for STATION MESSAGE
DETAIL RECORDING [S-10].
9. CALL FORWARDING-ALL CALLS can be overridden, allowing Station B to initiate or transfer
calls back to Station A.
10. STATION-TO-STATION CALLING [S-11] must first be provided.