NEAX2400 ICS Business Features and Specifications
Page 134
NDA-24143, Issue 4
C-12 Call Waiting - Terminating
Interactions (cont’d)
3. To answer a CALL WAITING - TERMINATING call from a D
term
, press the ANS key. The
answering party can alternate between the calls by pressing the ANS key.
4. Enabling ATTENDANT LOOP RELEASE [A-6] (System Data 2, Index 6, Bit 7), a call Camped-
On to a station via the Attendant Console will wait at that station for the time set in Index 145.
When the preset time has elapsed, the call will return to the Attendant Console.
5. If ATTENDANT LOOP RELEASE [A-6] is not provided and CALL FORWARDING - DON’T
ANSWER [C-3] via the Attendant Console is provided, a call extended to a station via the
Attendant Console will wait at the station for the time set in Index 141 and will then be forwarded
to the destination station for the time set in Index 145. Index 145 is the total time before recall.
When that time expires, the call will return to the Attendant Console.
6. When CALL FORWARDING [C-2, 3, 5] is in effect, the forwarding operation occurs before CALL
WAITING-TERMINATING is allowed, unless the CALL FORWARDING - OVERRIDE [C-26]
feature is applicable. If CALL FORWARDING-OVERRIDE [C-26] is used, the call will wait. After
a call has been forwarded, the call may wait at the new station if CALL WAITING-TERMINATING
is allowed.
7. BUSY VERIFICATION [B-3]: This feature is denied to a station that is in a CALL WAITING-
TERMINATING state.
8. EXECUTIVE RIGHT-OF-WAY [E-1]: This feature is denied to a two-party connection that is in a
CALL WAITING-TERMINATING state.
9. STATION HUNTING [S-7, 8, 9]: This feature takes precedence over CALL WAITING-
TERMINATING.
10. LINE LOCKOUT [L-3]: CALL WAITING-TERMINATING is not allowed to a station in LINE
LOCKOUT [L-3]
11. OUTGOING TRUNK QUEUING [O-2]: CALL WAITING-TERMINATING is not allowed on any
station involved in THREE-WAY CALLING [T-2].
To Next Page
Loading...
