NEC NEAX 2400 ICS - Page 199

NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Page 169
Call Forwarding - Busy Line - Outside C-60
Operating Procedure (cont’d)
3. The LCD displays:
Target Number*
D
term
Series E
Note:
*An entered abbreviated number is translated into the forwarding number and the first eight digits are
displayed.
To cancel CALL FORWARDING - BUSY LINE - OUTSIDE from a multi-line D
term
:
1. Press the multi-line key of the station to which CALL FORWARDING - BUSY LINE-OUTSIDE is
to be cancelled.
2. Lift the handset or press the “SPKR” key; receive Dial Tone.
3. Press the CALL FORWARDING - BUSY LINE - OUTSIDE feature key; receive Service Set Tone.
The LED of the associated feature key will go out. The LCD displays;
D
term
Series E
4. Replace the handset or press the “SPKR” key.
Service Conditions
1. CALL FORWARDING - BUSY LINE - OUTSIDE may be set or cancelled by either a station user
or the ATTENDANT CONSOLE [A-3].
2. Stations may be assigned this feature via CLASS OF SERVICE - INDIVIDUAL [C-15]
programming in System Data.
3. CALL FORWARDING - BUSY LINE - OUTSIDE data remains in the data memory, even if the
system is reinitialized or in the event of a power failure.
4. A maximum of 12 digits, including trunk access code, can be stored.
5. For CALL FORWARDING - BUSY LINE - OUTSIDE, Speed Call List numbers may be
programmed as the destination telephone number. This permits the sent digits to exceed the 12-
digit maximum.
6. When using this feature, either the calling station or the forwarding station is recorded by SMDR
[S-10] as the originating station of calls forwarded. The selection between the above stations is
determined through System Data.
FWD SET XXXXXXXX
(Time Display)
FORWARD SET XXXXXXXX
(Time Display)
FWD CNCL XXXXXXXX
(Time Display)
FORWARD CANCEL XXXXXXXX
(Time Display)