NEC SL1100 - Figure 2-85 Removing the Plastic Knockout and Replacing the Main-Cover; Figure 2-86 Connecting a LAN Cable

7. Cut and remove the Plastic Knockout for VoIP connector, then replace the Main-Cover and fasten
two screws.
Two screws
Hooks
Main-Cover
Plastic
Knockout
Figure 2-85 Removing the Plastic Knockout and Replacing the Main-Cover
8. Connect the VOIPDB-C1 to an Switching hub using an LAN Cable.
The LAN Cable must pass two times (two rounds) through the Ferrite Core as below. (Ferrite
Core is attached with VOIPDB-C1)
VOIPDB-C1 board (CN1)
Ferrite Core
VOIP
to HUB
LAN Cable
30 - 50 mm
(1.181″ - 1.967″)
Pass 2 times
< Bottom View >
Figure 2-86 Connecting a LAN Cable
9. Refer to the SL1100 Programming Manual for detailed programming instructions.
The VoIP feature requires system configuration.
For the details of setting and operation, refer to the SL1100 Features & Specifications Manual
(separate issue).
SL1100
ISSUE 5.0
2-62 Installation