NEC SL1100 - Figure 2-96 Hook-Switch Hanger; Figure 2-97 Wall-Mount Screw Guide; Figure 2-98 Mounting the Multiline Telephone

2. Remove the switch-hook from the unit. Turn the tab toward the top. Then slide the hook-switch
into position. Refer to Figure 2-96 Hook-Switch Hanger on page 2-69.
Hook-switch hanger Hook-switch hanger
Figure 2-96 Hook-Switch Hanger
3. Install two screws into a wall. The screw heads must be remained about 3 mm (0.12″).
7 - 9.5 mm
(0.28″ - 0.37″)
83.5 mm
(3.287″)
Minimum 10 mm (0.39″)
3 - 4 mm
(0.12″ - 0.16″)
1 - 3 mm
(0.04″ - 0.12″)
Figure 2-97 Wall-Mount Screw Guide
4. Mount the telephone on the wall.
Wall-mounting
holes
Wall side
Figure 2-98 Mounting the Multiline Telephone
ISSUE 5.0
SL1100
Hardware Manual 2-69