NEC SL1100 - Cards; General; Unpacking; Table 2-9 Expansion Cards

SECTION 3 INSTALLING THE EXPANSION INTERFACE CARDS
3.1 General
Enhancements
• The 000E-B1 PCB mounted on the KSU required Main software V1.5 or higher.
Up to two expansion interface cards can be installed per KSU.
Table 2-9 Expansion Cards
Expansion Interface
Card
Description Note
IP4WW-080E-B1 8 digital extensions card
IP4WW-008E-B1 8 analog extensions card
IP4WW-000E-B1 0 trunk/extension card for Analog Trunk
IP4WW-4COIDB-B1 4 analog trunk daughter board (Mount on the 084M-B1/080E-B1/008E-
B1/000E-B1)
IP4WW-1PRIU-C1 1 PRI (PRI/T1) card
• The function of IP4WW-000E-B1 card is just a mounting card for the 4COIDB.
• The 4COIDB-B1 can be installed in following combinations;
Daughter Board
Option Unit
084M-B1 080E-B1 008E-B1 000E-B1
4COIDB-B1 Yes Yes Yes Yes
3.2 Unpacking
Unpack the 080E-B1/008E-B1/000E-B1/4COIDB-B1/1PRIU-C1 and check it against the following list.
Inspect for physical damage.
Table 2-10 Expansion Card Packing List
Items List of Contents QTY Note
IP4WW-080E-B1 080E-B1 PCB (with PKG Spacer) 1
Nylon Spacers 2
Metal Spacers 2
Screws (with circular washer) 2
IP4WW-008E-B1 008E-B1 PCB (with PKG Spacer) 1
Nylon Spacers 2
Metal Spacers 2
Screws (with circular washer) 2
IP4WW-4COIDB-B1 4COIDB-B1 PCB 1
Nylon Spacers 2
4COIDB Label 1
Metal Spacers 1
Screws (with circular washer) 2
SL1100 ISSUE 5.0
2-42 Installation