NEC SL1100 - Figure 2-155 Combo Star and Daisy-Chain Layout; Setting up Your Repeater

Figure 2-155 Combo Star and Daisy-Chain Layout
6.3.2 Setting Up Your Repeater
Setting up the repeater involves four basic steps:
1. Install the AC adapter on the repeater unit.
2. Register the repeater to the base.
3. Position the repeater at the proper installation site.
4. Install the repeater in its final location.
Use ONLY the power adapter that came with your repeater. A different power adapter may cause an
electrical hazard or damage the repeater.
You can register up to six repeaters to a base. Repeat these steps as needed.
ISSUE 5.0 SL1100
Hardware Manual 2-107