NEC SL1100 - Figure 2-164 Base Mounting Dimensions; Figure 2-165 Handset Front View; Figure 2-166 Charger Top View; Handset and Charger

Be sure the wall material can hold the weight of the base.
1. Hold the base in its final location and mark the screw location based on the measurements shown
in Figure 2-164 Base Mounting Dimensions on page 2-116.
Figure 2-164 Base Mounting Dimensions
2. Insert the appropriate anchors for the wall material.
3. Insert the mounting screws into the anchors, leaving about 1/4 inch of space between the screw
head and the wall.
4. Connect the Ethernet cable and route the cord as shown in Figure 2-164 Base Mounting
Dimensions on page 2-116.
5. Place the base over the screw heads and slide it down into place.
6.4.3 Handset and Charger
Figure 2-165 Handset Front View on page 2-117 provides a front view of the handset and
Figure 2-166 Charger Top View on page 2-118 provides a top view of the charger.
SL1100
ISSUE 5.0
2-116 Installation