NEC SL1100 - Figure 2-136 Inserting Screws for Wall Mounting; Figure 2-137 Wrapping the AC Adapter Cord Around the Strain Relief; Figure 2-138 Placing the Charging Unit on the Wall

1. Insert two mounting screws as shown below. Allow about 3/16 of an inch between the wall and
screw heads for mounting the telephone.
Figure 2-136 Inserting Screws for Wall Mounting
2. Plug the AC adapter in the charging unit. Wrap the AC adapter cord around the strain relief.
Figure 2-137 Wrapping the AC Adapter Cord Around the Strain Relief
3. Place the charging unit on the posts of the wall screws and push down until it is firmly seated.
Figure 2-138 Placing the Charging Unit on the Wall
4. Plug the AC adapter into a standard 120 Vac wall outlet. Refer to Figure 2-138 Placing the
Charging Unit on the Wall on page 2-94.
SL1100
ISSUE 5.0
2-94 Installation