NEC SL1100 - Figure 2-156 Back View of the DTL-RPT-2 Repeater; Table 2-29 Repeater LED Patterns

These procedures refer to items on the back of the DTL-RPT-2 Repeater:
Figure 2-156 Back View of the DTL-RPT-2 Repeater
During registration, the LED on the front of the repeater will blink. The table explains what the LED
blink patterns indicate.
Table 2-29 Repeater LED Patterns
State Meaning
Steady On The repeater is registered to a base and has a good signal from that base (or an-
other repeater registered to that base).
Slow blink (one blink per second) Standby mode. The repeater is not registered or cannot be connected to the regis-
tered base.
Flicker (2 rapid blinks per second) The repeater is in registration mode (it is looking for a base to register to).
SL1100 ISSUE 5.0
2-108 Installation