Networking Manual 8 - 1
DHCP Client
8DHCP Client
SECTION 1 DHCP CLIENT
Warning: When the VoIPDB is installed on the CPU, the built-in LAN port
on the CPU becomes disabled. Only the LAN port on the VoIPDB is
operational.
DHCP Client will access an external DHCP server every time the LAN
cable is connected to the CPU/VoIPDB, or when the system is powered
up. The system can receive the following information from the DHCP
server: IP Address, Subnet Mask, and Default Gateway.
Conditions
The DHCP Server should be configured to provide the system the
same IP address every time. For example, in the DHCP server
extend the lease time to infinite, or setup the server to provide the
same IP address based on the system’s MAC address.
When changing PRG 10-63-01 (DHCP Client Enable/Disable) a
system reset is required for this change to become effective.
DHCP Client can set the following programs automatically; however,
other IP related programs (such as PRG 84-26) have to be set
manually as required.
IP Address: PRG 10-12-01 (CPU), PRG 10-12-09 (VoIPDB)
Subnet Masks: PRG 10-12-02 (CPU), PRG 10-12-10 (VoIPDB)
Default Gateway: PRG 10-12-03
DHCP Client (PRG 10-63) and existing DHCP Server feature (PRG
10-13) cannot be used at the same time.
To Next Page
Loading...
