Issue 6.0 NEC SL1100
13 - 8 SL Net
When assigning Diffserv values (for SL Net) go to program 84-10-01 and change the
type from Disabled to Diffserv. Then in program 84-10-07 assign the value for the
signaling (H.323) and voice (RTP/RTCP) packets. The next table shows an example
where the signaling packets are to be tagged as Class Selector 4 and the voice
packets are to be tagged as Expedited Forwarding.
After changes are made to Program 84-10 the system will need to be reset before the proper
values are inserted into the IP packets.
6.1 Conditions
CPU software 1500 (Version 1.50) or higher is required.
A maximum of five nodes and a total of 168 ports (below Version 3500)
or 256 ports (Version 3500 and above) total throughout the network.
InMail ports do not count against the 168 port (below Version 3500) or
256 port (Version 3500 and above) capacity.
This feature is only supported when networked with another SL1100; no
other system types are available.
Each system must be individually licensed for this feature with the
following license: SL-SYS-SL-NET-LIC.
Each system requires a VoIPDB.
Each site must have different extension numbers assigned. The same
extension number cannot exist at multiple sites.
Figure 13-3 Setup Example
To Next Page
Loading...
