NEC SL1100 - Layer 2 Priority Control

Issue 6.0 NEC SL1100
9 - 14 IP Multiline Station (SIP)
9.1 Layer 2 Priority Control
Layer 2 priority control can be enabled on an Ethernet switch, if it supports
VLAN tagging. This allows layer 2 prioritization.
Using a switch that supports 802.1p allows:
 priority control
 reduction of unnecessary packets (e.g., broadcast packets) and
provides circuitry by restricting a broadcast domain
9.1.1 Programming Layer 2 Priority Control
To program Layer 2 Priority Control for IP Phones VLAN/QoS:
1. Press the Menu button on the IP Phone to enter the telephone
program mode.
 This enters the IP program mode to select the settings for the
individual phone. The flashing item is the current selection.
2. Press OK, EXIT, SAVE softkeys to save the entries and return the
telephone to idle.
1. DHCP Mode
:
:
:
:
6. Advanced Setting
1. Speed & Duplex
2. VLAN Mode
3. VLAN ID
4. VLAN Priority
Set VLAN Disable/Enable
Set same ID as 87-09-02
Set VLAN Priority
1. Network
Settings