NEC SL1100 - SIP Caller ID

NEC SL1100 Issue 6.0
Networking Manual 7 - 15
6.3 SIP Caller ID
Program/Item
No.
Description/
Selection
Assigned Data Comments
14-01-24
Basic Trunk Data Setup –
Trunk-to-Trunk Outgoing
Caller ID Through Mode
0 = Disable
1 = Enable
Default = 0
Enable/Disable the Trunk-to-
Trunk Outgoing Caller ID
Through Mode. This option
allows Caller ID from the
original outside caller to be
displayed when a trunk is
forwarded off premise. This
option can be used only with
PRI and SIP trunks.
21-17-01
IP Trunk (SIP) Calling Party
Number Setup for Trunk
1 ~ 0, *, # (to equal up to 16
digits)
Default not assigned
This program assigns the Caller
Party Number for each IP trunk.
The assigned number is sent to
the central office when the
caller places an outgoing call. If
the Calling Party Number is
assigned by both 21-17 and
21-18/21-19, the system uses
the entry in 21-18/21-19.
21-19-01
IP Trunk (SIP) Calling Party
Number Setup for Extension
1 ~ 0, *, # (to equal up to 16
digits)
Default not assigned
 Version 5.0 or higher: Select SIP
Profile 1-2.
Assign the Calling Party
Number for each extension.
The assigned number is sent to
the central office when the
caller places an outgoing call. If
the Calling Party Number is
assigned by both Program
21-17 and 21-18/21-19, the
system uses the data in
Program 21-18/21-19.