NEC SL1100 - Programming Names and Text Messages; Table 5-2 Keys for Entering Names

NEC SL1100 Issue 6.0
Networking Manual 5 - 5
SECTION 5 PROGRAMMING NAMES AND TEXT MESSAGES
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you
to enter text. Use the following chart when entering and editing text. When using the
keypad digits, press the key once for the first character, twice for the second
character, etc. For example, to enter a C, press the key 2 three times. Press the key
six times to display the lower case letter. The name can be up to 12 digits long.
VOL 
Scroll forward through a list of entry numbers (e.g., from extension etc.)
or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling backward.
Table 5-1 Keys for Entering Data (Continued)
Keys for Entering Data
Use this key... When you want to...
Table 5-2 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ ¨ Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü 
 Enter characters:
 + , - . / : ; < = > ? B E  S  ¢ £
# # = Accepts an entry (only required if two letters on the same
key are needed - ex: TOM). Pressing # again = Space. (In
system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)