NEC SL1100 - DHCP Client Setting

Issue 6.0 NEC SL1100
5 - 20 Programming
Description
Use Program 10-63 : DHCP Client Setting to enable or disable the SL1100 to
receive its IP Addressing information from a DHCP server.
Conditions
 This feature can not be enabled if Program 10-13-01 (DHCP Server) is enabled.
Feature Cross Reference
 None
Program 10 : System Configuration Setup
10-63 : DHCP Client Setting
Level:
IN
Input Data
Item
No.
Item Input Data Default Description
01
DHCP Client Mode
0 = Disable
1 = Enable
1
If you are using IP Phones/IP
trunks it is recommended to not
use the DHCP Client function, a
static IP address is preferred. If
you are going to still use DHCP,
the DHCP server should be set up
so that the same IP address is
always provided to the SL1100.
If this program is changed a
system reset is required.