NEC SL1100 - Basic Setup

NEC SL1100 Issue 6.0
Networking Manual 13 - 13
Basic Setup
Program
Number
Program Name/Description Assigned Data
10-12-09 VoIPDB IP Address
Assign the IP Address for the
VoIPDB.
If a VoIPDB is installed in the
system, NEC recommends
setting program 10-12-01 to
0.0.0.0. All connections to the
system will be made through the
VoIPDB.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =172.16.0.10)
10-12-10 VoIPDB Subnet Mask
Assign the subnet mask for the
VoIPDB card.
Refer to the programming manual for all the
possible valid subnet mask entries.
(default =255.255.255.0)
10-12-03 Default Gateway
Assign the SL1100’s default
gateway IP address.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =0.0.0.0)
84-26-01 VoIP Basic Setup (DSP)
Assign the IP address that is
used for Voice Communications
across the network. The IP
address assigned here MUST
be within the same network as
the IP address assigned in PRG
10-12-09.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =172.16.0.20)
11-01-01
* System Numbering
Assign the leading digit/digits of
the remote SL Net systems as:
(8) Networked System Access.
Example 1: The Remote SL Net
system is going to use
extensions 200 ~ 299 then the
digit 2 would be assigned as:
(8) Networked System Access.
Example 2: The Remote SL
Net system is going to use
extensions 1200 ~ 1299 then
the digits 12 would be assigned
as: (8) Networked System
Access.
.
0 = Not Used
1 = Service Code
2 = Extension Number
3 = Trunk Access Code
4 = Individual Trunk Access Code
5 = Operator Access
6 = F-Route
8 = Networked System Access
9 = Dial Extension Analyze
(Refer to the SL1100 programming manual
for the default values.)