Networking Manual 12 - 1
All DSP Busy Indication
12
All DSP Busy Indication
SECTION 1 INTRODUCTION
The All DSP Busy feature is used to alert users via telephone displays
and/or Alarm reports when all DSP (VoIP) resources in the system are
being used. This can be used to trouble shoot issues or to alert when the
current hardware might need to be upgraded to a higher capacity.
Alarm Message Format:
The Alarm message for will vary depending on what type of resource is
unavailable, and will be displayed on display telephones and included in
reports.
Table 12-1 Alarm Types
Parameters Description
STA DSP for IP Station Calls Were All Busy.
TRK DSP for Trunk Calls Were All Busy, includes SIP.
To Next Page
Loading...
