NEC SL1100 - Page 189

NEC SL1100 Issue 6.0
Networking Manual 9 - 55
84-23-10
DR700 Multiline
Basic Information
Setup – Number of
Password Retries
The number of times an incorrect
password can be entered when
the security key is pressed.
If set to (1), only one attempt is
allowed. When number of
password retries is met an error
message displays on the phone:
Incorrect security code password
entered, press call key to contact
an administrator
Range: 0 ~ 255
Default is 0
X
84-23-11
DR700 Multiline
Basic Information
Setup – Password
Lock Time
Time to leave the terminal Locked
Out after entering the wrong
security code.
Range; 0 ~ 120
Default: 0
Default is 0
X
84-23-12
DR700 Multiline
Basic Information
Setup – Reference
Number
Assign the network admin
telephone number. When the user
presses the Call key to contact the
network administrator, this number
is dialed.
Up to 32 Digits
(0~9, *, #, P, R, @)
Default is No Setting
X
84-23-13
DR700 Multiline
Basic Information
Setup – Media
Type of Service
Assign the IP terminals MEDIA
TOS values.
Range: 0x00 ~ 0xFF
(0~9, A~F)
Default is 00
X
84-23-14
DR700 Multiline
Basic Information
Setup – Refer
Expire Timer
The valid period of the REFER
subscription.
Range: 0 ~ 65535 Sec.
Default is 60
X
84-24-01
DR700 Multiline
CODEC Basic
I n f o r m a t i o n S e t u p
– Number of G.711
Audio Frames
Amount of audio in each RTP
packet.
Range: 1~4
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
Default is 2
X
84-24-02
DR700 Multiline
CODEC Basic
Information Setup
- G.711 Silence
Detection Mode
Select whether to compress
silence with G.711. When there is
silence, the RTP packet is not
sent.
When VAD is enabled the CPU will
stop sending packets but the IP
Phone will continue to transmit
silence packets.
0 = Disable
1 = Enable
Default = 0
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3