NEC SL1100 - Page 35

NEC SL1100 Issue 6.0
Networking Manual 5 - 3
5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02: Programming Password Setup.
SECTION 3 HOW TO EXIT PROGRAMMING MODE
To exit the programming mode:
To exit programming mode, first exit the programming options mode.
1. Press Mute to exit program options, if needed.
2. Press Speaker. If changes were made to the system programming, Saving
System Data is displayed.
3. When completed, the display shows Complete Data Save and exits the
telephone to idle.
 To save a customer database, a blank Compact Flash (CF) is required.
Insert the CF into the CD-CP00-US and, using Program 90-03, save the
software to the Compact Flash. (Program 90-04 is used to reload the
customer data if necessary.) Note that a Compact Flash can hold only one
customer database. Each database to be saved requires a separate card.
Password
User
Name
Level Programs at this Level
12345678 sltech 2 (IN) Installation(IN): All programs in this section not listed
for MF, SA, and SB
0000 ADMIN1 3 (SA) System Administrator - Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-23, 10-24, 10-25, 10-28, 10-29, 10-45, 12-02,
12-03, 12-04, 12-08, 15-01, 15-07,1 5-09, 15-10, 15-11,
20-16, 20-34, 21-07, 21-14, 22-04, 22-11, 22-17, 25-08,
30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06,
90-07, 90-19, 90-57, 90-58, 90-59, 90-65
9999 ADMIN2 4 (SB) System Administrator - Level 2 (SB):
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
Program Mode
Base Service OP1 OP2