PROGRAMMABLE AC POWER SOURCE
vi
3.3.3 Using Soft-keys ................................................................................................. 50
3.3.4 Closing Windows ............................................................................................... 51
3.3.5 Entering Values (Numerical Entry Box) .............................................................. 51
3.3.6 Entering Strings (Character String Entry Box).................................................... 53
3.3.7 Using Shortcut Operations (SHIFT Key) ............................................................ 54
3.4 Using the Continuous Function ................................................................................. 55
3.4.1 Setting the AC/DC Mode and the Signal Source ................................................ 55
3.4.2 Setting the Output Range .................................................................................. 58
3.4.3 Setting Waveforms ............................................................................................ 59
3.4.4 Setting the Output Voltage (Single-phase Output) ............................................. 61
3.4.5 Setting the Output Voltage (Polyphase Output) ................................................. 62
3.4.6 Setting the Output Frequency ............................................................................ 64
3.4.7 Setting the Output On/Off Phase ....................................................................... 64
3.4.8 Turning the Output On or Off ............................................................................. 65
3.4.9 Using the Measurement Function ...................................................................... 66
3.4.10 Switching the Display Format (RMS/AVG/Peak) of the Measured Value ............ 68
3.4.11 Enlarge Display Letters for the Measured Value ................................................ 69
3.4.12 Clearing the Output Current Peak-hold Value .................................................... 72
3.4.13 Switching the Target Phase of which the Measured Values are Displayed
(Polyphase Output) ............................................................................................ 74
4. Advanced Operation .......................................................................................................... 77
4.1 Using Limiter, Setting Limiter .................................................................................... 78
4.1.1 Use Peak Current Limiter .................................................................................. 78
4.1.2 Using RMS Current Limiter ................................................................................ 80
4.1.3
Using Voltage Setting Range Limit ..................................................................... 82
4.1.4 Using Frequency Setting Range Limit ................................................................ 83
4.1.5 About Wattage Limiter ....................................................................................... 85
4.2 Using Sequence Function ......................................................................................... 86
4.2.1 Basics ................................................................................................................ 86
4.2.2 Parameters of Sequence Function ..................................................................... 89
4.2.3 Example of Output Using Sequence Function.................................................... 92
4.2.4 Process Flow in a Step ...................................................................................... 92
4.2.5 Edit a Sequence ................................................................................................ 94
4.2.6 Load a Sequence ............................................................................................... 97
4.2.7 Execute a Sequence ........................................................................................ 101
4.2.8 Save a Sequence ............................................................................................ 105
4.2.9 Clear/Rename Sequence ................................................................................. 109
4.2.10 Set so as the Sequence Function is Selected at Power-on .............................. 113
4.2.11 Sequence Control by CONTROL I/O ............................................................... 114
4.2.12 Screen Overview ............................................................................................. 114
4.2.13 Change Output Parameter during Output ON .................................................. 116
4.3 Using Power Fluctuation Testing (Simulation) Function .......................................... 118
To Next Page
Loading...